IMG_20241211_074542052[1].jpg
IMG_20241211_074705081[1].jpg
IMG_20241211_074718300[1].jpg
IMG_20241211_074732304[1].jpg
IMG_20241211_074542052[1].jpg
IMG_20241211_074705081[1].jpg
IMG_20241211_074718300[1].jpg
IMG_20241211_074732304[1].jpg

Lancia Scorpion Montecarlo E-brake lever trim

$62.00

An exact duplicate of the original E-brake trim piece on the Lancia scorpion / montecarlo. They are 3d printed in strong UV resistant ASA plastic and they have a separately printed flexible rubber plate where the E-brake lever protrudes that is welded and bonded into place. I’ll be putting one of these on my own green scorpion restoration.

There is some extremely minor edge imperfections which I could not deal with in the printing setup. I don’t think you’ll care, they are very minor. The underside has some slightly rough areas too but most importantly the retaining tabs are Very strong which is most important. And it’s the bottom, so who cares, right ??

Quantity:
Add To Cart

An exact duplicate of the original E-brake trim piece on the Lancia scorpion / montecarlo. They are 3d printed in strong UV resistant ASA plastic and they have a separately printed flexible rubber plate where the E-brake lever protrudes that is welded and bonded into place. I’ll be putting one of these on my own green scorpion restoration.

There is some extremely minor edge imperfections which I could not deal with in the printing setup. I don’t think you’ll care, they are very minor. The underside has some slightly rough areas too but most importantly the retaining tabs are Very strong which is most important. And it’s the bottom, so who cares, right ??

An exact duplicate of the original E-brake trim piece on the Lancia scorpion / montecarlo. They are 3d printed in strong UV resistant ASA plastic and they have a separately printed flexible rubber plate where the E-brake lever protrudes that is welded and bonded into place. I’ll be putting one of these on my own green scorpion restoration.

There is some extremely minor edge imperfections which I could not deal with in the printing setup. I don’t think you’ll care, they are very minor. The underside has some slightly rough areas too but most importantly the retaining tabs are Very strong which is most important. And it’s the bottom, so who cares, right ??